(T)eflon(S)hadow
R.I.P. Neda
+456|7121|Grapevine, TX
The short version.... I knew just enough to get in trouble with DIY....
1. Bought EVGA 7800GS AGP vid card. (expectations way high!)
2. Bought upgrade 430w Thermaltake power supply. (Mummm more power)
3. Turned on system to an awful long tone from motherboard. It never stopped until I shut down system.
4. Reinstalled original power supply. No long tone, but no Video Input to monitor.
5. Reinstalled ATI 9550. No Video. Hooked up Motherboard video, still nothing. Tried Two different 7800 GS cards. ( Yes I have two at the moment)
6. Reinstalled Thermaltake power, no long tone, still no video, not even one little beep you get with a successful BIOS load.
7. I think I blew my motherboard.

My question for all you A+ guys is, what does a long sustained tone(beep) mean from the motherboard?

System: Sony VAIO Intel 478 socket Northwood 2.7 ghz
             1 GB Ram
             ASUS Motherboard
Brasso
member
+1,549|6922

problems.  might even just be a disconnected power LED.

Last edited by haffeysucks (2006-06-03 17:11:56)

"people in ny have a general idea of how to drive. one of the pedals goes forward the other one prevents you from dying"
Ki][mE
OMG H4XOR!
+51|6855|I'm a Viking....Norway
does EVERYTHING getting power?overheated something maybe?or the motherboard couldn't handle the graphic card?

I'm not an expert though
(T)eflon(S)hadow
R.I.P. Neda
+456|7121|Grapevine, TX
everything is getting power, all leads are hooked up. Original power supply is in with ATI vid card, so I'm back to square one, well with out Video. Headed  to Fry's Electronics, if I'm lucky Ill pick up a new 478 socket motherboard...

So disappointed, only 1500 points until next promotion... no telling now...
gburndred
tiga tiga tiga tiga tiga woods ya'll
+95|6930|Calgary,AB,Canada
When a PC starts up, the first thing it does is run a Power-on Self Test (POST) to test the computers hardware. If it detects an error, you will be notified by either a number of audio beeps or an error message on the screen. This page helps to explain what the error message or audio beeps mean.




Beeps - Error Message - Description
1 short - DRAM refresh failure - The programmable interrupt timer or programmable interrupt controller has probably failed.
2 short - Memory parity error - A memory parity error has occurred in the first 64K of RAM. The RAM IC is probably bad.
3 short - Base 64K memory failure - A memory failure has occurred in the first 64K of RAM. The RAM IC is probably bad.
4 short - System timer failure - The system clock/timer IC has failed or there is a memory error in the first bank of memory.
5 short - Processor error - The system CPU has failed.
6 short - Gate A20 failure - The keyboard controller IC has failed, which is not allowing Gate A20 to switch the processor to protected mode. Replace the keyboard controller.
7 short - Virtual mode processor exception error - The CPU has generated an exception error because of a fault in the CPU or motherboard circuitry.
8 short - Display memory read/write error - The system video adapter is missing or defective.
9 short - ROM checksum error - The contents of the system BIOS ROM does not match the expected checksum value. The BIOS ROM is probably defective and should be replaced.
10 short - CMOS shutdown register read/write error - The shutdown for the CMOS has failed.
11 short - Cache error - The L2 cache is faulty 1 long, 2 short - Failure in video system An error was encountered in the video BIOS ROM, or a horizontal retrace failure has been encountered.
1 long, 3 short - Memory test failure - A fault has been detected in memory above 64KB.
1 long, 8 short - Display test failure - The video adapter is either missing or defective.
2 short - POST Failure - One of the hardware tests have failed.
1 long - POST - All tests passed.





Also look at this: Repeating (endless loop)=Memory error (Check for improperly seated or missing memory)


That should tell you whats wrong

Last edited by gburndred (2006-06-03 17:45:36)

Janus67
Tech God
+86|6887|Ohio, USA
it definitely isn't too big of a power supply.  personally i have a strong distaste for thermaltake psus.  I have read they have improved, but after having two fail on me I stay away from them.

did you give power to your graphics card?

try resetting the cmos

P4 and 24pin both plugged in?

monitor plugged in (I know sounds dumb)?
KungfuBeer
The King of Beers
+31|7022|SoCal
Plug in the 4 Pin socket thats next to the processor.  Needs both 24 pin and the 4 pin +12v one.
InnerMonkey
Member
+62|7010
Generally speaking, the mobo should only draw what it needs.  The rating on a PSU is for what it *can* output under load, not what it dumps continuously.  It may be that it dumped too much to a particular rail for the mobo, but that's extrememely rare, and typically a faulty PSU if it did that.

I *think* most ASUS boards use an Award Bios, but your best bet is to find the exact model mobo you have, and search for the error code list for that board.  In my experience (take it as you will, YMMV), a long beep like that is caused by memory problems (poorly seated or faulty ram sticks).  Swap them out, one at a time, maybe even try different slots, and see what you get.
Janus67
Tech God
+86|6887|Ohio, USA
I just realized that you replaced the power supply that was inside of your Sony computer.  A lot of times those systems ship with proprietary parts (down to the power supply) that uses different wiring (mixing different cables etc) that plug into specialized connectors on the motherboard.  By putting in the new power supply you may have indeed fried your motherboard.

I won't say it for sure, as one long beep to me reminds me of a RAM error, that is at least with my DFI and last Epox board.
Cybargs
Moderated
+2,285|7008
probably static shock fried it,  but yeah manufactured pcs come w/ proprietary parts... could be ram or dead bios
https://cache.www.gametracker.com/server_info/203.46.105.23:21300/b_350_20_692108_381007_FFFFFF_000000.png
XxUNDEROATHxX
=(1C4L)=underOATH
+52|6948|Chandler, AZ
**plays Taps**

im sorry, you may have indeed fried your board. By plugging in a non-propritory PSU, the wrong voltages went to the wrong parts of teh motherboard, which led to the wrong result, and now your ded computer...

Id suggest plugging in your old PSU, and sending it to sony, and blame it on viruses...
InnerMonkey
Member
+62|7010

Janus67 wrote:

I just realized that you replaced the power supply that was inside of your Sony computer.  A lot of times those systems ship with proprietary parts (down to the power supply) that uses different wiring (mixing different cables etc) that plug into specialized connectors on the motherboard.  By putting in the new power supply you may have indeed fried your motherboard.

I won't say it for sure, as one long beep to me reminds me of a RAM error, that is at least with my DFI and last Epox board.
Argh...I missed that Sony part.  I don't know if they use proprietary PSU pinouts, but a little forum searching and google should give an answer to that in a few minutes time.  It's an easy thing to test for, but you'll need a multimeter, the knowledge of how to use it, and a little more time.  I'm going to guess that you don't want to go that route.  On a positive note (but still not fixing your dead PC), many manufacturers are dropping proprietary PSUs, as it makes sourcing the parts a little more expensive.  Dell supposedly stopped this years ago, but Compaq still did it years after that.  I've near zero experience with Sony though.  There PCs are generally overpriced, so most folks don't have them.  Sony also has a long long history of proprietary BS, so you may indeed have fried the mobo.

It may not help at this point, but.......Good luck!
(T)eflon(S)hadow
R.I.P. Neda
+456|7121|Grapevine, TX
Wow, thanks for all the good answers, and opinions. The Sony propriety psu and motherboard combo is undoubtedly the problem, so off to shopping I go. (Unfortunately, I will be with out a PC that will play BF2 for awhile.) 

I hear Taps playing, have a moment of silence for me. I'll be back on the Battlefield, just not soon enough. Damn I will miss playing, but the astonishing thing is, I know, I will still be back here on BF2s.com most of the weekdays, checking in on the ongoing battle of BF2.

Semper Fidelis,
SGTMAJ (T)eflon(S)hadow
USMC
philipjip
Member
+4|6933|England
I have recently brought a new graphic card nvidia 6800 was using a 5700le, i changed the card turned the pc on and i got a black screen and 1 continues beep ??? after a couple of attempts i reverted back to the 5700 and pc was sweet again any ideas ??

intel Pentium 4 3.0/1 gig ram/400 watt power supply/gigabyte 848p mobo agp
pdanrichey
Member
+5|7099

philipjip wrote:

I have recently brought a new graphic card nvidia 6800 was using a 5700le, i changed the card turned the pc on and i got a black screen and 1 continues beep ??? after a couple of attempts i reverted back to the 5700 and pc was sweet again any ideas ??

intel Pentium 4 3.0/1 gig ram/400 watt power supply/gigabyte 848p mobo agp
The video card is bad...

Board footer

Privacy Policy - © 2025 Jeff Minard