everything i write is a ramble and should not be taken seriously.... seriously. ♥
good work dude, +1
Nice tut +1
There are still easier ways imo (like I said on xfire). I think konfusion covered it pretty good in his. Not bad though, everyone does stuff different
You do know there is a much easier way to make a rounded sig?
You select the whole sig the same way as you did, then right click -> make selection.
Then go to SELECT in the menu and choose INVERSE. Then just click delete, it will delete the non-rounded parts...
You select the whole sig the same way as you did, then right click -> make selection.
Then go to SELECT in the menu and choose INVERSE. Then just click delete, it will delete the non-rounded parts...
I simply copied it to be able to make the shadow........Zimmer wrote:
You do know there is a much easier way to make a rounded sig?
You select the whole sig the same way as you did, then right click -> make selection.
Then go to SELECT in the menu and choose INVERSE. Then just click delete, it will delete the non-rounded parts...
everything i write is a ramble and should not be taken seriously.... seriously. ♥
Cool!
+1
+1
Nice toot, I don't do my own graphics, as I'm a lazy alcoholic. Like the way you presented it, very nice. Have a nice +1 cookie.
I guess.tazz. wrote:
I simply copied it to be able to make the shadow........Zimmer wrote:
You do know there is a much easier way to make a rounded sig?
You select the whole sig the same way as you did, then right click -> make selection.
Then go to SELECT in the menu and choose INVERSE. Then just click delete, it will delete the non-rounded parts...
Maybe make the text a bit more readable. Like...arial.
Can that be done with a better font? that hurts my eyes... >_<
Fenris_GreyClaw wrote:
Can that be done with a better font? that hurts my eyes... >_<
Use new layer -> Image -> Apply Image. It's a lot easier.
you could just make a rounded rectangle "box" at the start.. that would have been way easier than that..
Yeah, make your rounded box at the start, then make your sig on a new document, drag it on to the rectangle. Make sure your sig is above the rectangle layer, than alt+click between the 2 layers to merge them together.
I Knew there was a way, couldnt figure it out though, thanks.....Entertayner wrote:
Use new layer -> Image -> Apply Image. It's a lot easier.
everything i write is a ramble and should not be taken seriously.... seriously. ♥
Feather selection is also a simple way to do this.