Pages: 1

 

2005-12-20 20:24:54
DyLonX5
Member
+0|7029|Friendswood, Tx
Ok I just got my VGU back from ATi and I'm trying to configure my controls to my liking and I keep getting this error message. I've reset to defult and also erased all of the controls and set them all myself and I still get this message. Is there any trick I'm not doing? please help anyone.

Dylan
2005-12-20 20:28:53
Rapturesan
An African or European swallow?
+0|6943
I've had this same problem with both mouse axis', It thinks the mouse axis bound in a different area of controls should cross over to flying for some reason.
2005-12-20 20:46:44
oberst_enzian
Member
+234|6958|melb.au
i had this prob - the only way i fixed it was to restore defaults, clear all of the keys i wanted to change first, delete any that had the key i wanted to assign to, and only then start assigning. annoying and time consuming, but it worked
2005-12-20 21:20:29
DyLonX5
Member
+0|7029|Friendswood, Tx
Well I'm trying to put my numeric pad keys as fallowed:

Num1 - weapon 3
Num2 - weapon 2
Num3 - weapon 1
Num4 - weapon 4
Num5 - weapon 5
Num6 - weapon 6
Num7 - weapon 7
Num8 - weapon 8

There are no other controls being used by these keys anywhere that I can see. I will try to erase the mouse axis keys and trying again.

 

Pages: 1

Board footer

Privacy Policy - © 2024 Jeff Minard