CPU temperture adverage?

2006-12-23 09:50:01

#1

SealXo: Member; +309|6912

I'm runing with a pentium D and it says I'm running a 30C system... yeah ok thats good, but then it says "-127c CPU temperature"

I'm just woondering what the usual adverage is for most computers fan cooled.

2006-12-23 10:10:12

#2

Stormscythe: Aiming for the head; +88|6926|EUtopia | Austria

30°C with an Intel Pentium D?
Did you throw your PC into an icy lake or something?

2006-12-23 10:28:21

#3

SealXo: Member; +309|6912

Its in a mini tower auminum case and it has a massive heatsink in it. about 6 inches x 4 inches

2006-12-23 10:46:13

#4

kylef: Gone; +1,352|6870|N. Ireland

My C2D runs at 25-35C..

2006-12-23 11:27:16

#5

The Stillhouse Kid: Licensed Televulcanologist; +126|7018|Deep In The South Of Texas

You can be sure the -127C is a false reading. Your 30C reading, that's while the CPU is idle, correct? What you really should look into is the load temp. Run Stress Prime 2004 and see what kind of temperature you get. Lower is always better, but so long as you stay under 50C at 100% load you're not in any danger.

2006-12-23 13:06:12

#6

doc. josh: Member; +48|6921

my 5000+ runs at -10*C so it pwnes yours

2006-12-23 13:07:07

#7

Vilham: Say wat!?; +580|7143|UK

Lol my desktop was running at 90 degrees C, the PSU is gone.

2006-12-23 13:08:43

#8

CommieChipmunk: Member; +488|6946|Portland, OR, USA

doc. josh wrote:
my 5000+ runs at -10*C so it pwnes yours

phase change??

My 4600+ X2 runs at 35-40C

I'm guna get an E6600 and Tuniq tower, so we'll see

2006-12-23 13:11:58

#9

Jussimies: Finnish commander whore; +76|6961|Finland

Lol with my heatsink it is idling at around 35 and it never goes above 56.

2006-12-23 13:22:11

#10

fierce: I love [fiSh]; +167|6945

Core 2 Duo E6600 @ 18 ° in idle mode with a Zalman 9500 AT.

2006-12-23 13:28:35

#11

swedge: Member; +23|6835|haggis hill

i just installed mother board monitor on my pc and ran the config wizard but its not coming up with any of my temperatures, i have an Asus m2n Sli Deluxe

https://img1.putfile.com/thumb/12/35616281166.jpg

2006-12-23 13:36:58

#12

Kmar: Truth is my Bitch; +5,695|6977|132 and Bush

-127c means it is probably trying to read from a sensor that is either not hooked up or malfunctioning
If you use speed fan I think the defualt settings are.
Temp1= Motherboard
Temp2=CPU

Temp3 is the one that is usually not hooked up.

I never exceed 34c, I am using a heatsink.

https://tampastorm.smugmug.com/photos/110425419-M.jpg

Xbone Stormsurgezz

2006-12-23 14:09:33

#13

lxcpikiman: imbad @ bf2; +70|6972|Toronto-Canada

i'm so jealous of u kmarion!!!!

2006-12-23 14:38:47

#14

Kmar: Truth is my Bitch; +5,695|6977|132 and Bush

lxcpikiman wrote:
i'm so jealous of u kmarion!!!!

Don't be. I started with this:
I'm looking through some of my old Christmas photos...lol
Old school fellas.

https://tampastorm.smugmug.com/photos/118495854-S.jpg

This is the Vic-20 I was opening.
http://www.old-computers.com/museum/com … 2&st=1

Last edited by Kmarion (2006-12-23 14:41:39)

Xbone Stormsurgezz

2006-12-23 14:43:40

#15

samfink: Member; +31|6932

well, put it one way- I don't have a radiator in my computer room, the computer IS the radiator. j/k, but i suspect it may be overheating.I use my computer to keep my feet warm

2006-12-23 14:45:48

#16

462nd NSP653: Devout Moderate, Empty Head.; +57|7060

Kmarion wrote:
lxcpikiman wrote:
i'm so jealous of u kmarion!!!!
Don't be. I started with this:
I'm looking through some of my old Christmas photos...lol
Old school fellas.
http://tampastorm.smugmug.com/photos/118495854-S.jpg

This is the Vic-20 I was opening.
http://www.old-computers.com/museum/com … 2&st=1

Had one too...a 64 and 128 too. Man I'm old.

2006-12-23 14:46:52

#17

bob-brainiac: Member; +6|7089|belgium

I have a p4d 840 so dual 3200 ghz its overclocked to dual 3830 ghz. running stable and has a temperature of 32 degrees when idle. stressed 46 degrees. thats when playing bf2 at maximum settings.

2006-12-23 14:51:12

#18

Leprechaun56: Proud Infantry Whore; +31|6960|U.S.A

Kmarion wrote:
-127c means it is probably trying to read from a sensor that is either not hooked up or malfunctioning
If you use speed fan I think the defualt settings are.
Temp1= Motherboard
Temp2=CPU

Temp3 is the one that is usually not hooked up.

I never exceed 34c, I am using a heatsink.
http://tampastorm.smugmug.com/photos/110425419-M.jpg

dam nice job on the wiring, did you build that?

2006-12-23 14:54:24

#19

Kmar: Truth is my Bitch; +5,695|6977|132 and Bush

Leprechaun56 wrote:
Kmarion wrote:
-127c means it is probably trying to read from a sensor that is either not hooked up or malfunctioning
If you use speed fan I think the defualt settings are.
Temp1= Motherboard
Temp2=CPU

Temp3 is the one that is usually not hooked up.

I never exceed 34c, I am using a heatsink.
http://tampastorm.smugmug.com/photos/110425419-M.jpg
dam nice job on the wiring, did you build that?

OEM originally but I have since redone everything on my own. Thank you.

Xbone Stormsurgezz

2006-12-23 14:56:31

#20

Leprechaun56: Proud Infantry Whore; +31|6960|U.S.A

Yea thats pretty sweet, Ive redone my wiring twice, and it still dont look as good.
Heres mine:

https://img.photobucket.com/albums/v493/tdcleprechaun/Picture011.jpg

I have put the fan wires in the back of the case sense i took the pic.

Last edited by Leprechaun56 (2006-12-23 14:59:05)

2006-12-23 15:04:59

#21

Kmar: Truth is my Bitch; +5,695|6977|132 and Bush

Not bad considering your sli.

Xbone Stormsurgezz

2006-12-23 16:43:34

#22

Des.Kmal: Member; +917|6994|Atlanta, Georgia, USA

leetkyle wrote:
My C2D runs at 25-35C..

mine runs from 32-40

Add me on Origin for Battlefield 4 fun: DesKmal

2006-12-23 16:45:44

#23

The Stillhouse Kid: Licensed Televulcanologist; +126|7018|Deep In The South Of Texas

swedge wrote:
i just installed mother board monitor on my pc and ran the config wizard but its not coming up with any of my temperatures, i have an Asus m2n Sli Deluxe

Could be that your board isn't supported by MBM, since it's no longer being updated. Use Speedfan instead.

2006-12-23 16:51:28

#24

Yaocelotl: :D; +221|7026|Keyboard

Kmarion wrote:
Don't be. I started with this:
I'm looking through some of my old Christmas photos...lol
Old school fellas.
http://tampastorm.smugmug.com/photos/118495854-S.jpg

No offense but what fucking ugly hair was that. I hate it because I also had it like that .

2006-12-23 18:27:33

#25

doc. josh: Member; +48|6921

Kmarion wrote:
-127c means it is probably trying to read from a sensor that is either not hooked up or malfunctioning
If you use speed fan I think the defualt settings are.
Temp1= Motherboard
Temp2=CPU

Temp3 is the one that is usually not hooked up.

I never exceed 34c, I am using a heatsink.
http://tampastorm.smugmug.com/photos/110425419-M.jpg

can we see more pics of your rig. mainly of that 8800GTX

BF2S Forums CPU temperture adverage?

doc. josh wrote:

lxcpikiman wrote:

Kmarion wrote:

lxcpikiman wrote:

Kmarion wrote:

Leprechaun56 wrote:

Kmarion wrote:

leetkyle wrote:

swedge wrote:

Kmarion wrote:

Kmarion wrote:

Board footer